Prior to this last failure, the extractor was fitted well in its grove. Not binding or loose. I have not disassembled it yet. Yes a round did not fire. Someone elsewhere advised me to look at the bolt face for any cracks or chips. He says even very small ones can cause extraction problems...
It has been a while since I worked on this. All the advise above has been helpful. The chamber has been checked for any ruff spots and lightly cleaned using a brass brush and a hand drill. The gas port and system has been cleaned. All looks and feels good to my touch and sight.
I reinstalled...
Thanks ya'll!! You have given me the insight needed. A lot of the suggestions I have already tried. But after reading all your messages and some of the links, I think I will look into the extractor adjustment. The rifle and action were cleaned very well. The new extractor does look better than...
I have been researching about the Remington 742 and its notorious extraction/ejection/jamming problems. I have one right now that will not extract the empty shell. 1st shot, every shot. It doesn't even like to extract a loaded round when manually operated. I have replaced the extractor with a...
Hey All.
I have a Win model 37, 16 ga that will miss fire sometimes..... When it happens the primer strike is lite/not deep enough for ignition. Sometimes it will take 3 or 4 tries to get it to fire. Then it may work fine for 5 or 6 shots and do it again. All other times the primer strike is...
Pilot of a Cessna 182 gets another plan. It's an old Piper Cub. He has to have training for the new aircraft because it has different flight characteristics.
You get a new pistol. You need to train on the new firearm because it has different characteristics........
No one just rises to the...
I like breakfree CLP. Used it for years. Also like marvel mystery oil. Smells a lot like large equipment in the woods. And hoppies #9 for most stubborn cleanings and bore cleaning.
Thanks! Yall have made my day. Some of your responses are hilarious.
When I asked, I already knew the answer but the statement has been bothering me for some time. I just had to vent I guess.
AND thank you to all the Vets on here for your service. God Bless you and your families!
On another...
I have been around a while but not posted.
I have been shooting guns in one form or another for over 40 years. The other day someone made a statement (or recommendation) that when training (any firearms training) I/you/everybody should not wear ear protection. They said this is "to get your...
I have looked at 223 load data on the hodgdon site and others. Can I safely assume that these data are using standard SR primers and not magnum SRP For min and max loads.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.