Search results for query: *

  1. A

    Quality die for 1/2-28 ??

    That is all great information ! Thanks very much for your response. Right, I have all types of die wrenches so I'm good that way. I've ordered end mills and other things from both of them over the years and completely forgot to check them. I'll go with one of them, thanks again !!
  2. A

    Quality die for 1/2-28 ??

    It's time to buy a new 1/2-28 die, I ordered one from amazon as Brownels was out of stock. I went to use it to clean up threads on an AR because 3 threads about half way in had been hit at some point. The amazon die immediately felt like it was going to start cutting and not just thread on to...
  3. A

    How is this legal ?

    Yes, thank you ALL for your help and info. I appreciate it !!
  4. A

    How is this legal ?

    Thanks Med, Yes I was thinking that the max for a pistol was 26" and had been told that. I also thought it because I read somewhere that the ATF considered a pistol to be fired with one hand and to be concealable. So I can attach a 14.5" or any length barrel to an AR PISTOL lower and be...
  5. A

    How is this legal ?

    I've spent days searching forums and reading ATF regs and even purchased the Florida Firearms Law book from Jon H Gutmacher and I've yet to find an actual answer that is more than an opinion. My question is, if the overall length of a pistol is to be 26", fired by one hand and be considered...
  6. A

    S&W 6906 Grips

    I bought my 6906 new back in the 80's and still love it, hundreds of rounds through it and not one single malfunction ! My only problem is the factory grips, just too slippery if my hands have the slightest bit of moisture. I installed the Hogue wrap around on it, even though my hands are...
  7. A

    Ruger 44 Super Blackhawk parts ?

    Thanks very much Bill. I'll call Ruger in the morning. Should have started there !! EDIT: Am I correct that a Blackhawk hammer will fit the Super ? Just without the wide thumb spur ?
  8. A

    Ruger 44 Super Blackhawk parts ?

    Thank you all. I did check with Numrich first, sold out. Then CTD. I'll check the others now. Thanks again
  9. A

    Ruger 44 Super Blackhawk parts ?

    Hi all, I need to find a hammer and trigger for a new model Super Blackhawk. Several places I've checked are out. Any suggestions ? Thanks!
  10. A

    Winchester 94AE 44 Mag Part Question

    Thanks Jim. The ones I'm finding on Numrich for the AE are showing sold out. I just looked again, are you seeing that it's available ? My serial# is 5504xxx if that makes any difference
  11. A

    Winchester 94AE 44 Mag Part Question

    I just got a 94AE 44 Mag and it's missing the right side (loading gate side) cartridge guide. Is there any difference for this guide regarding Angle Eject or Top Eject models ? The one pictured below states it's for a Top Eject... Thanks for any advice
  12. A

    Savage Model 67 series E Slide question

    OK, thanks. I'll silver it too. Appreciate the help !
  13. A

    Savage Model 67 series E Slide question

    Can anyone tell me if this part of the Savage 67 12ga slide is supposed to be welded on ? Looks like it was spot welded but on one I'm working on, it's completely separate. Pic is from Numrich's site. Thanks for any advice, Steve
Back
Top