Search results for query: *

  1. A

    Dillon RL 550 question

    For your Op Rod question try posting directly on Dillon's forum. They are good about answering posts but you are going to have to give them a little more detail than you supplied here. https://www.dillonprecision.com/forum.html Also if you look on the Dillon site there are instruction on how to...
  2. A

    9mm 124gr vs 125gr

    I have done this for my 9mm rounds. Start low and work up! I typically use RMR thick plated which can be loaded using FMJ data up to 1500fps but I still start in the lead range and work up until I find a load that cycles my gun well and is accurate.
  3. A

    550 primer slide bearing hack

    The thread your looking for is on Brian's forum, http://www.brianenos.com/forums/index.php?showtopic=181925. I made one myself and it does help. I also had some side to side slop that caused the primer bar to chatter a bit as it slides out but instead of a bearing I used a small spring clamp to...
  4. A

    Dillon 550 Potential Issue

    Dillon has several videos on cleaning and maintenance. https://www.youtube.com/watch?v=cJuMsTIKsaU
Back
Top