Search results for query: *

I installed a magnet on the back of my Hornady AP press to hold my screwdriver and hex wrenches. The magnet is available at Ace Hardware or Amazon. A 1/4" x 1/2" long bolt holds it securely in the pre-drilled/tapped holes on the backside of the press. I can not think of any inherent risk from...

Sunray - thank you! I have not been able to find much load data for this combination. I currently load 124 gr. JHP's with 5.1 grains of Unique. The range of data I have found over the years for this powder and JHP combination is in the 4.7 gr. to 5.4 gr. range. I hope to find addition forum...

Hello forum! Does anyone have a favorite 9 mm load using this bullet and Unique? If not for the ACME version, how about another manufacturers 124 gr. or 125 gr. coated lead cast bullet? I know I'm old school using Unique. I have a good stock of it and I like it in my .38 Special, .44...

Thanks for everyone's input. I am going to ditch the idea of using Unique. Although a fun target load, I really couldn't use it for even short distances on Deer. There really isn't a good reason for me to have a target only round. It was fun diving into this with all of you. I really...

Thank you for your constructive input. I am unsubscribing myself from Cast Boolits. Since I am not an expert on that forum, I received much less helpful input on this same post content.

I own a Glenfield Model 30 that I am thinking about loading for. I found a fair amount of 30-30 Winchester load data using lead bullets and Unique (I almost exclusively use Unique with my handgun loads). I was curious if anyone would share with me their thoughts and load data using the...