Search results for query: *

8/21/18 purchased suppressor 9/02/18 check cashed 10/15/19 still pending (408 days) Single shot trust! They do a good job of discouraging purchases of NFA items.

Thanks for the feedback everyone. To err on the side of caution, and safety wise. I’ll go ahead and stick to the components the load data calls for. An accident due to trying to save a few extra $’s isn’t worth it in the long run.

7mm Rem Magnum, Hunting(Whitetail & Elk) Browning XBolt. Using Norma cases, Nosler Partition Bullets.

Hey y’all! I’m moving up to start loading some cartridges for one of my rifles. Load data calls for Fed 215 primers. I already have plenty of win. large rifle magnum primers from loading my 460 mag. Does the brand really matters as long as they’re large rifle magnum primers? I’m guessing not!

OK, I really appreciate to y'all s thoughts on the matter very much. And I'm going to go ahead with the suggestions that were brought up. Thanks Toprudder, Crestoncowboy, and buck460XVR!

Ok y’all I’m loading for the 460 mag in a 8” s/w XVR, 240gr. Hornady XTP mag. bullet, Starline brass, WLRM primers and RamShot Enforcer powder. Lyman #50 manual has the starting load at 37.5gr.- 41.5gr(max). Western powders load data has the same bullet with a load of 42gr.- 47gr.(max)! The only...

I believe I misunderstood what they where saying. Here's the link. https://loaddata.com/Cartridge/460-Smith-Wesson-Magnum-460-SW-Magnum-Hodgdon-Pistol-Data/2458

Understood, Thanks again.

Thanks ArchAngelCD! I didn’t think it would matter either. Just want to double check with more experienced loaders to be sure.

My mistake. I should have said. I’m using large rifle magnum primers (WLRM) per the Lyman manual. Hornady load data uses (WLR). So I guess the best question I could ask is. Can the Hornady brass handle the WLRM primer safely? The one I have loaded looks perfect, fit wise.

Hello all, I’m pretty new to hand loading so bear with me. I’ve loaded 45 Colt, .357 Mag, and now I’m moving to 460 s&w Mag. I’ve done well so far and I was thinking I had the 460 down until I came across something that said all brass might not be able to handle the LRM primers. I bought star...