Search results for query: *

They extracted fine, I was concerned they wouldn't

I was actually considering that but assumed it was unsafe

I bought two boxes of Federal hollow point for 38 special: ( I can't recall bullet size but it was not 158 grain.) All but 5 rounds were near impossible to load into a 357 and 38 snub nose; I actually had to to push rounds in with my thumb. I have not gotten a response from Federal and wonder if...

my old 1911 Thanks

Thanks. I love my 1911 but dislike flying brass I have to pick up. The more I shoot 38 special and 357 the more I like them. With practice, I have become more accurate with them than a 45.ACP. ( With reloads Ive put holes next to holes at 7 yards with snubnose revolvers.)

thank you. Thanks. Im most interested in potential damage and accuracy. I assume with newer firearms damage should not be an issue if used occasionally.

Thank you.

I have 110 grain bullets I plan to reload and shoot, (infrequently,) from a Ruger GP100, a Ruger LCR 38 Special or EAA 357. I have read the velocity of this load can be hard on the forcing cone but wonder if this would be a problem with infrequent use in these revolvers. All three are less than...

Thanks. Again I was curious about LEO opinions as the 38 special was used for quite a while.

I suspected it was effective but was curious as to LEO opinion.

Aside from the higher capacity ammo of semi-automatic pistols,was there any flaws in the use of the 38 special? How effective was it for law enforcement?