Search results for query: *

Aren't choices great. I have reloading dies for 5 different pistol caliber, I don't want another. So don't think I'll be picking up a 9mm anytime soon. Shoot the biggest caliber you can comfortably shoot. Blonde, Brunette or Red head. They are all fun. ;)

I'm looking to add a lever action to the collection but can't seem to find what I would consider an ideal rifle. I'm looking for the following features; 1892-1893 Winchester replica chambered in 357Mag/38Sp 20-22 inch octagonal barrel stainless steel receive and barrel maybe a pistol...

I haven't been able to find a holster for a 3 inch SP101 with the following features; belt clip Inside waste band middle of back position thumb break leather Any suggestions? I want to use this holster for backpacking, something I can stash in the backpack and tuck in a MOB postion...

I had a friend try out some 357Mag loads and he noticed the same thing. He is a lot more experience with revolvers than I and found the behavior odd. But... we couldn't find any lead shaving or anything else wrong with the piece. Tried some Blazer 357Mag 158 grain JHP with similar results, a...

Thank you all for the replies so far, this gives me a good place to start looking. Sorry for the lack of information, here are the answers to some of the questions. @ 25-20 WCF: Yes, I'm wearing eye protection. Can't help it if I want to see more than 6 inches in front of my nose. I am...

I picked up a SP101, 3 1/16 inch, .357 Mag and wanted to know if when firing 357 defensive loads(Magtech 125grain JHP 1319 fps per the box) if it is normal to feel a little bit of hot powder being blown back into your face? The cylinder to forcing cone gap is less that 0.008 inch (smallest...

Catfish, I have been searching for the same answer. Unfortunately I do not have an answer yet. But you might want to let people know what you want to use as far a bullet, since the weight and style of bullet will change some behavior of powders. Also the barrel length will have an affect on...

I was able to vote. But not using Firefox only Internet Explorer. So I assume not being able to post a vote is a cookie accepance thing. As of this post here are the results of the ABC poll;

Built two on Oly MX lowers about 3 years ago. Everything went together well, both rifles are reliable. Only thing I have noticed is the magwells are on the tight side of spec. I would not hesitate on building on a forged Oly lower.

With regards to e-mailing Sig customer service. When I sent Sig a quesiton about a mis-feeding P229 my first e-mail was replied to with an automated message stating that I needed to reply to that message in a specific way or my first message wouldn't go to a real person. :banghead: I...

What are the recommended lights for a Sig P229DAK? First use will be as a nightstand gun. I'm concerned with having a switch that is easily reachable with the trigger finger to activate, a pressure switch would be even better but I have not seen any of those around. Also I'm leaning towards...

Sorry don't mean to hijack the thread.... but Zak, did you try pushing the 70gain bullets any faster? Was the 2700+fps the best accuracy load? Or is the velocity due to the solid copper construction of the Barnes? What was the load? Oh, what COL? Zak, as I let you know last week...