Search results for query: *

tite-group find the minimum load for the 250gr and start there. Work up a bit, watching for pressure etc. Enjoy

35 Rem I load the 35Rem Marlin 336 using either the 180gr by Speer or the 200gr by Remington. I use BL-c-2 powder and weight out 37 gr for each. Super accurate load out to 100yds. Probably ever further but I have not tried. Shooting here in the brush country of south Tx., 100 yds is a long...

Rust NO-NO-NO-NO do not use the scotch brite. Go to the hardware store and buy one of those little brass brushes that look like a toothbrush. Use that and get your mold hot. If all you have is surface rust, this will take it out. Then oil it well with a good gun oil,

boolets I like car knocker's supplier best, but those of us who have to have them shipped in, then I recommend www.northeastbullet.com For 1000 of the 200gr RNFP in 45LC, $46 delivered to your front door. 38/9mm/40sw are all cheaper than that.

375 try 4198 either H or IMR. Worked pretty well for me

crinkled brass 1. pull the bullet, save 2. dump the powder, save 3. decap primer, save 4. dump the brass :D :D :D

45 loads Nothing wrong with that 255gr SWC at 1050. Works for me but I prefer the 250gr RNFP. As far as the NM Vaquero is concerned, any p[ublished load for the 45LC by speer, Hornady, Lyman et al should be good to go. Course, with bear, I would prefer the 44mag with the 240 JSP pushed by...

Prices Their prices are quite a bit higher than www.northeastbullet.com I get my 200gr RNFP 44-40 bullets, sized to .428 for $46 per thousand delivered to my front door. My 44 cal. 200gr sized to .430 and 45's sized to .452 for the same price, delivered. Check it out.

cast bullet Try www.northeastbullet.com. $43 for a box of 1000 delivered to your front door. You can get hard or soft cast with either moly or wax lube. You can't beat the price or the bullet.