I have a rather large amount of new Canadian IVI .308 brass. I am attempting to use it in a .308 M1. I ran the brass through a RCBS Small Base Full Length sizing die. The rifle keeps ramming about 1 in 10 bullets back into the case. I tried getting a Lee Collet Die to work the case neck a...
I recently found mention of ammunition from Buffalo Bore using 147gr bullets with a muzzle velocity of 1175fps:
http://www.buffalobore.com/index.php?l=product_list&c=26
Then I found Vihtavouri published data for their powder 3N38 in 2007 that says one can achieve 1207 fps with the 147gr...
There are lots of worrisome comments about peening in M1A and M1 rifles when loading 2520. Does anyone have any good loads they use in manually operated rifles? I have a bunch of it and would like to use it.
CDD
I have a Smith & Wesson K22 made right after WWII. The grip is a bit small for me. I'm looking for suggestions for a larger grip, preferably made by S&W. Any suggestions?
CDD
Anybody have any experience with these? I was given some of both. They were purchased about 1973. I shoot more .308 and .223 than anything else, mostly service rifle.
CDD
I have lots of Norma brass and Sierra 174gr Match King bullets. I have a wide variety of powders and primers.
I'm looking for suggestions as to powder, primer, and Over All Length. Also, if someone can suggest a bullet that works better in the Finnish M39, please tell me.
CDD
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.