Search results for query: *

you would be surprised how much the carpet and furnishings absorb the blast inside the home.

I have a set of S&W(Hogue) X frame grips on my 629. They are nice, but they only fit round butt guns click on the thumbnail for full size picture

without a doubt, my .50 BMG Rifle

I have S&W new X frame grip on my 629. I like it very much..

Sierra 53gr HPBTs and 37.5 gr of 4064 shoot great on paper in my Swift, but doesn't do the best on groundhogs. For the ground hogs I like 55gr Ballistic tips over 37.5 gr of 4064.

You don't shoot them from the hip. The proper technique for such a weapon is... Shoot from eye level, sight down the barrel, weapon fully extended at arms length. With strong hand (trigger hand) PULL back, with support hand PUSH forward.

nope, 8 rd mags still sell for around $100.00 :cuss:

I had to wait about 3 months for Tony to get to mine.

The HK sight takes a little getting use to, but I like them. I agree on the magazines. I have 4 10 rd mags, but I perfer the 8 rd. It looks better in the gun.

RCR29 , you going to install a front sight? I have a 870 with a 13.0 inch barrel, and I installed an Ithaca Military and Police brass bead on it.

it shoots great.

Tromix Saiga-12ga SBS

I don't have a clue how they arrive at the magic number of ten. I don't understand why ten is ok, but eleven is evil.

yes, but that is STATE law, not Federal.

at the moment, the 10 rounds mag limit only applies to imported semi auto firearms.

go here http://www.remington.com/pdfs/rempartslist2.pdf go down to page 37 242243 V-3 870 BBL 12/18 IC PARK BEAD (FIXED I/C NO CHOKE TUBE) $96.40 I ordered two of these last year. showd up in less than a week.

check out some .50BMG primers sometime. $260 per 1000!!

I have made a lot of pins from 17-4 heat treated to H900. I even made one for a MG-42 Machinegun and it is running just fine after 10 years..

is this what you are looking for? as far as I know, no one outside of custom work makes one in wood. I made this one for an old Wingmaster stock. It is easy to make, I did this one is a couple of hours.