Search results for query: *

So I bought a Pietta replica 1858 Remington New Model Army revolver a couple of years ago. I finally had time to take it out and shoot it last week. It shoots very low. I had to get within five feet to hit the coffee can I was using as a target, and it hit at the bottom of it when I aimed...

Shot mine for the first time today. It's accurate. My son's hand dropped the mag twice. You have to grip low. Limp wristing will result in failure to feed the next round. Otherwise, very nice and accurate. After my son was alerted to the limp wristing, all rounds were on target. As my son...

So I got the 1858 Remington with a 5.5 inch barrel from Cabelas, it's a Pietta, and I put the CCI number 11 magnum caps on it, no powder or ball just to test it out. It misfired on about 2/3 of them. I figured my caps must be bad, so I put them on my 1851 Colt and they fired just fine. They...

News Story Marion County District Attorney Press Release Audio of 911 Call This has generated a lot of controversy in my area, and was complicated by the officer involved being arrested on charges of sex abuse unrelated to the shooting. After listening to the 911 call and reading the...

I have six sons, one daughter, and another child on the way, undetermined what sex at this time. I would like to obtain a rifle for each of my sons, and a handgun for my daughter. If the polical climate changes, I anticipate existing rifles will likely be grandfathered in, and I can pass them...

On my lunch break I took my normal half hour walk and ended up by a pawn shop. I stepped in to peruse their offerings. I was flabbergasted. I found a 1917 Remington manufacture Mosin Nagant! But it had been badly bubba'd. A sporter stock had been put on it, the bolt turned down, the...

I have a brass framed Pietta 1851 Navy, .44 caliber. I was bored yesterday, and gave in to the urge to shorten it. It's kind of a spare pistol, I have a steel framed one also, so I felt okay playing with it. I have minimal tools in my garage, so I knew going into it that I would have to...

I'd like to replace the front sight on my 1851 Navy revolver, but I can't quite figure out how to remove it. Any suggestions? It's a Pietta from Traditions. Thanks in advance!:) happybrew