Thanks fellows.
I have changed springs when I first got, for a Chuck Taylor class. I have replaced the rear sight , but I guess I am either going to have to have some mill work done for the Wilson sights, or just sell it and upgrade to maybe a Scandium Commander Smith. I can't afford both...
I have a series 70 Colt Gold Cup that I have had for twinty five years. It has a Bar Sto barrel fitted by Irv Stone , Swensen amby safety and a few other goodies. The Problem I have had in the past is the sights. The rear sight has a pin that keeps the sight on, but I have replaced broken pins...
Does this Bill also address what I think is called The Castle Doctrine, meaning if you are attacked you may stand your ground instead of retreating.
Thanks, Jimmy
I have been calling legislators all day to, just to remind them to have some backbone and give Taft a good slap, and overide the veto for all the trouble he has caused if for no other reason.
A friend bought some years ago and he doesn't reload any more, so I guess I got lucky. How does it work in your 223 loads, and what do you shoot it in.
Jimmy
I just picked up three eight pound jugs of 2200, and eight thousand IMI 55 grain bullets. I guess I'll have to look for loads for my Mini 14 and the AR.
Have any of you used this powder, before ,and how did it work out...
Thanks , but thats not it either. I wish I had a scanner, but I don't. The die looks just like any other seating die, but on the side is a little oval shaped window about 2 inches high and three fourths of or an inch wide oval shaped.
Maybe someone out there has the same magazine article in a...
Thanks Ol Joe, but as the site you sent me to says"not for use in progressive
presses, and I think that I included in my first post that the picture in the article was of that die in a Dillon 550, just like mine. Thanks for trying to help though. I don't know what the vickers looked like, but...
I just checked the RCBS site and I can't find the same die in the picture. The RCBS dies have micrometer stems on top and the don't look the same. Maybe they changed them!
I have had a Dillon 550 for 15 years. Three years ago the ram wasn't lining up with the die as it should. I called Dillon, said send the press back. Two weeks later a brand new 550 came to my door by UPS. I don't know any one who has better Customer service than Dillon.
A while back Guns & Ammo came out with a magazine" The Book of th AR 15".
On page 150 there is a picture of a die set on a Dillion 550. The picture shows
a seating die with an oval shaped window in the side of the die, and you place the bullet in the window and it lines it up so it seats the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.