Search results for query: *

I like the lil' guns just fine. and...

Sounds like you're re-creating the Clayvon breacher round.

I have to admit, I'm a little confused (that's SOP) - Of course you had to verify your ID, but did they make any sort of issue with your state of residence? Here's my point; as y'all know that particular rifle is considered super duper naughty her in Cali; if you had still been a resident in...

You can dent an AK mag so much so that it fails? Wow. I did not know that. And that armorers kit is the cats pajamas!

Outstanding. I have lust in my heart for this one.

^ Yup, that's pretty much it. It sucks but that's the way it is until we change it.

Guy; I'll tell you up front that my approval process is not the one that is generally recommended; I managed an indoor range/retail store in Santa Clara for most of the 90's. We were also the local dealer for LEO weapons; H&K, FN, Bushmaster all the big name high speed low drag select fire...

Wow, that's a whole 'nother discussion.

Another guy with safes in his garage; it's an old house with a very small single car garage... that I couldn't fit my truck in even if I tried. I guess cars were smaller back when the house was built. My are bolted down pretty solid and my garage door, when open, doesn't face the street...

Yup; Kershaw has great CS; I bent the belt clip on my Blur (sitting in my car the seatbelt slipped under the clip and when I exited... SPROING.) I emailed them to find out what size torx screws they used and the very nice lady from customer service volunteered to sent me a new clip and screws...

I'm in the same boat; don't use a pocket holster but do have the occasional snag when drawing the 637 from IWB. Need to practice my Hackathorn Rip! Or just have the hammer bobbed. Or upgrade to a 642.... *sigh* I did do a little shade tree gun smithing an took down all the sharp edges on...

Wow, is it just me or are the extractor and ejector HUGE.

Here's an even better one; when someone that was unfamiliar with handguns would be handling a Glock in the store, invariably, with the slide locked back, they'd say that the barrel was bent. Nope, it's just tilted, like 95% of all semi-automatic handguns out there it uses a tilting barrel...

^ Yup.

Nope, no off hand shooting, no 'shot and move', no barricade. Just plain vanilla, draw and fire.

Guy, here's a cut-n-paste from my post over at calguns.net when I requal'd for my CCW. Mine is issued by the Santa Clara County Sheriff's Office but is recognized by San Francisco where I live. ~~~~~~~~~~~~~~~ I thought it might be interesting for people to know what the exact procedure for...

Are you sure about this? The "101 California massacre" was a factor in the Clinton 1994 Federal AW ban, but as far as I know had nothing to do with Winchester pulling BTs from the shelves. They *did* stop selling to the public, but it was for touchy feely fuzzy PR reasons and not related to any...

I'd be curious as well; I have a 386 Sc/S which I'm going to have to get a holster for pretty soon.

Lyman! Seriously the probably make exactly what you're looking for; I have a set on my Marlin 1894 Cowboy and I just love em' - a set of 66 rear aperture coupled with a 93 front globe sight. Tang sights as well. Take a look.

I say leave it if you can. I covered mine in 100 mph tape to silence the rattle. It clears my light and that way if my side sling adapter ever goes TU I can adjust on the fly to the stock sling swivel.