Search results for query: *

  1. C

    Scare at my friend's house

    I'd rather have a buddy walking around my house then the police.
  2. C

    Pierced primers

    Thanks for all of your input. The distance from the breech face to the cylinder is 0.067" and the firing pin protrusion is 0.047". I don't know if that is OK or not. Is the specification for firing pin protrusion available somewhere on line? The load is maybe as much as 5.1 gr of Unique...
  3. C

    Pierced primers

    So... I took my girl friend out to the shooting range for the first time last night. We had a bunch of 38 special ammo that I loaded up, 158 gr SWC, 5 gr Unique. They were just a little hot for her S&W 642(?) snubbie. She shot one round and I finished the other four in the cylinder. When I...
  4. C

    LSWC load for 41 mag

    Thanks Steve. I'll give that a try. After starting this thread last night I ordered Oregon Trail's loading manule. Hopefully it will have lots of data for lead rounds. bc
  5. C

    LSWC load for 41 mag

    I need a load for a 215gr LSWC in 41 mag. It is to be a practice/plinking round and I'd like it to be around 800 f/s. A recipe would be fine if someone has one. A point in the direction of a good source of LSWC loads for 38special/357, 41 mag, 44 special and 45 acp would be even better. I...
  6. C

    Seeking Input: Old Family L.C. Smith

    Get it set up so you will shoot it and take it hunting. bc
  7. C

    winchester model 55 .22

    Try these folks, Numrich. Just found out about them today so I haven't done any busyness with them yet. http://www.e-gunparts.com/ bc
  8. C

    Anyone have a SW 1911?

    I picked one up last fall. I haven't put a lot of rounds through it yet but so far I really like it. I don't shoot factory ammo and it has tolerated my reloads quite well. bc
Back
Top