Search results for query: *

Hi Deep South. "The questions answer is so obvious, I don't even know why he wrote the article to begin with. A 6 year old can see why there's concern if they pay Just a little bit of attn." But these days just pointing a finger at someone in school demonizes the 6 year old kid. And I...

Just wanted to pass this along. Couldn't disassemble the wife's Beretta because of slide interference. Found the two roll pins holding the ejector had backed off to the left. If this happens to you can just see the pins protruding if you pull off the grips and shine a bright light under...

Normally I don't post but just watched a video of a police action detaining a number of innocent men, women, and children in order to corner a bank robber, and had to comment. Although there will be questions about the legality of the detention what caused me to post was one uniformed...

small Benchmade I wish I had a small bladed knife like this when I was a kid: I recently purchased an Activator....2" drop point blade, stablized winewood handle, D2 steel, husky leather sheath. It isn't much for slicing up watermelon but I expect to use it for everything else (including...

folder safety A number of years ago Benchmade advertised a knife with a "safe" linerlock (a collaberation between Spyderco and Benchmade), which I found to be set in so you had to make a definite and forcefull action to close the blade. I then thought to try to "accidentally" close the blade...

The CA requirements Hi all. My first post so I hope I don't get it tooo wrong. I just had to chime-in on this interesting thread. As I remember the requirements the one which gets gun manufacturers dander up, out here, the most is the drop test requirement. Although, for the life of me...