Search results for query: *

I know that malfunction (researched it earlier), so that's ok. I was more hoping for pointers at to how to tell that the shell latches are about to give away.

Since the person aiding me with the conversion is also a CNC machine shop nut, I doubt making a replacement would be an issue (although costly). I'm hoping to find a 3" that suits my fancy, but 2 3/4" should be plenty to fit my needs. How can I tell the shell latches are due for...

Thanks for the valuable info! I'll consider myself warned. :) Could put a barrel shroud on the project gun, but I'm not convinced of the usefulness nor of the esthetics. Especially if it's a model that can slamfire... Good point. That's about what I had in mind, yeah. Might depend on...

Thanks for the feedback, VA27. I was indeed expecting the 4+1 to be the best fit. I'll start looking for a suitable shotgun, but no idea when I'll find something that suits my fancy, so don't expect any quick feedback on this. :) Also if anyone has the exact measurements asked above for...

Hey everyone, thanks for all the feedback! Strictly speaking, I could go further, as anything with a full length below 60cm (23.6") AND a barrel smaller than 30cm (11.8") simply becomes a 'pistol'. In practise getting a permit for it wouldn't be very easy, but law-wise it doesn' really make a...

Hi everyone, Eurotrash here. Been lurking for 3 years, and finally have something to post. :) I'm planning one doing something totally loathsome: chopping up a perfectly good Ithaca 37 12 gauge. :what: Before someone questions the legality (rather than questioning the morally...