Recently picked up a Rem. 770 bolt gun in 30-06 and loaded up some test loads for it last week. I was using mixed brass by Win. Rem. and Fed. along with CCI LR primers and I use three different powders Alliant 2400, H-4198 and Unique. The two bullets I used were the Lee 170 gr. FP and the Lee...
Got my new hopper in today for my old RCBS DUO measure, it's a DRAM WORX pyrex hopper with a built in baffle. The original plastic hopper that came with it is usable but you pretty much have to tape it on to keep it in place.
How do you guys trim your 7.62 x 25 cases, Lee doesn't make a case length gage trimmer for the round except by custom order,nobody makes a trim file die I have a Lyman trimmer but I'm not sure which pilot to use or if one will work any suggestions would be appreciated.
Ok got her today bluing was a little rough on the dust cover but the guy does bluing so he is going to reblue it for me free of charge,it took me good part of the day to get all the cosmo out of it, I still need to take the stock off again and work a little more out of it on the inside.
I...
I am considering trying out some RN or FN Hard Cast bullets instead of the the usual SWC I normally use in my 357. I have no problems with the accuracy of the SWC,I haven't ever tried anything else and was wondering how the compared for plinking,target shooting and for hunting. Thanks Ron.
I'm pretty sure around the first of the year I'm going to scope my YUGO SKS I have considered several way to do this all being drill and tap type mounts (Choate) or universal rail. The two scopes I particular like and to keep my YUGO as close to original Sniper configuration as possible are...
Has anyone shot any of these,there pretty cheap bought in bulk and would be mostly use for plinking ammo in my 300 Sav. Also what loading data would I use for this type of bullet and can they be shot at regular rifle velocities.
I,m posting this from another post I read on some testing a gentleman did on this subject. Which ever way works for the individual reloader is up to them this is just his results after and extensive test. I have also found similar results using the Lee factory crimp die with all my rifles...
I went to the range with a friend of mine yesterday to help him set up his 7 mm Mag. and his 243. He was shooting Remington Core-lock 100 Gr. SP factory ammo in the 243. The 7 MM worked out fine last 3 shot group had all holes touching at 100 Yds. The 243 however was a different story it...
123 Gr. Soft Points
I spent about a day working on a load for my YUGO SKS. Using Winchester cases,trimmed to length with the Lee case length guage & cutter, CCI #34 Mil-Spec primers, AA1680 powder and the Hornady 123Gr. SP seated & crimped right on the cannalure. There is nothing special...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.