Use a 6v lantern battery.
http://www.pricecanada.com/p.php/Energizer-6-volt-alkaline-lantern-039800076632-606603/
2 aligator clips (1 red, 1 black).
http://www.radioshack.com/product/index.jsp?productId=2062227
2 co axial plugs - take a sensor to Radio Shack...
For the Mossy 500, you're SOL if it's a 5/6 shot. You need to get a new mag tube plus you will need different barrels.
The 930 should be the same as the 935.
Try something like this.
http://buy1.snapon.com/catalog/item.asp?P65=&tool=all&item_ID=5837&group_ID=601&store=&dir=catalog
http://www.samstagsales.com/amf.htm#hook_adjust
Use brass shims between the wrench and the nut.
P90shooter:
Have your Dad check out the G21SF.
I've always felt that the G21 felt like a brick in my hand - I like Glocks - but yesterdat I got to fire a G21SF, (SF = slim frame), I found it fit my hand very well and it felt like the recoil was a little less too.
Measure about 3" from the toe of the stock, cover with masking tape ans drill a hole 90 degrees to the stock a tad longer than the screw. Use a bar of soap on the threads to act as a lube then turn in to the hole - after removing the masking tape.
The tape is used to help prevent...
Prior to 1992, the 30/06 was used too.
I believe that it was the 1992 match that the 155gr was first used, so prior to that, anything went.
Read Handloader magazine #152, July/August 1991 article - Loading for the Palma by G. Sitton.
There are 2 ways that you can go.
1. Get an EGW undersize die (made by Lee, and Lee sells the undersize die too), or
2. Roll size you brass.
Case Pro 100 - which I have or a unit from Magma Engineering.
http://www.casepro100.com/
http://www.ehkco.com/magma/products.php
I have one with the KISS bulletfeeder and conversions and KISS adaptors for 4 calibers, all set up on there own toolheads.
I had to made a stand for the toolheads so as not to damage them if the fell over.
Since this picture was taken, the bullet drop has been installed on all of...
alsaqr:
You think IVI 70 was accurate?
DA 64 was possibly THE most accurate 7.62mm made in Canada.
Dominion Arsenals was the forerunner of IVI.
There are some other years of IVI that were accurate. 78/79, to name a couple of years, also, I believe, 84.
What about the contaminants from the cases getting on your dishware and cutlery?:what:
We are talking about lead etc.:eek:
Don't do it UNLESS the dishwasher is dedicated to case cleaning.
You are worried about the cost of a tumbler and media? A dishwasher is more expensive.:banghead:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.