Search results for query: *

What HE said^^^^^:)

The juice wouldn't be worth the squeeze...

I ALWAYS clean (wet ss tumble) my primer pockets...Factory new, clean. The one time you need to take a shot that might save your life, and all you hear is "click", it will be too late. No problem, if all your doing is shooting holes in paper. But, they're your reloads...you can do what you...

"If the "threat" is 200 yards away you do not need to be shooting at it." What HE said^^^^^^^

What RC MODEL said, My RCBS 30 carbine dies do the same thing, and after the bullet is seated, the case is very slightly bulged out...

After I take the SS tumbled cases out of the rinse water, I run them through the RCBS Swager with spots of water in the pockets. Makes a WORLD of difference swaging them.

I started my test loads @ 23gr and went up to 26gr, in half grain increments. We shall see what we shall see...

What HE said ^^^^^^

I'm just going to start with the lowest starting charge for the .223 (23gr), and work up to the Max 5.56 load (26gr) .5gr at a time. It has also been my experience that fastest isn't always the most accurate. Range time on Thursday...:D Thanks, guys...

I bought a Hornady New Dimension seating die, removed the seater stem and dabbed in a bit of 5 minute JB weld in the seater. I reassembled it and gently lowered the ram on a greased .223 round with my Nosler Custom Comp 69gr HPBT bullet loaded in it. After 15 minutes, I took the seater out...

My AR15 has a Wilde chamber. Since there are different loadings for .223 and 5.56, which one do I use? I load Ramshot TAC behind Nosler 69gr Custom Comp HPBT, and am looking for accuracy. Should I start at the lowest .223 load and end with the highest 5.56 load?..:confused:

I haven't touched a primer pocket since I got my HF wet tumbler. IT does the work.

I, for one, cannot understand HOW they stay in business...

-------------------------------------------------------------------------------- I've got a lot of steel cased AK ammo, and I have a few questions about it that I HOPE aren't stupid. First, what is the weak link in the ammo, as far as accuracy? I'm thinking it's the powder or the...

I deprime and size in two different steps. I deprime, SS tumble, then when the brass is spotless, I size...

By all means, reuse the primers. If they didn't go off upon removal, then they're reuseable...:D

Because they are not misable with water...

Military 5.56 ammunition is crimped because it will be used in an automatic capable weapon. The crimp is to insure that the bullets do not get loosened and moved in the cases. If Civilian .223/5.56 cases have sufficient neck tension, crimping is not at all necessary...unless automatic fire is...

What USSR said...

What HE said ^^^^^^