I've had problems getting my Safety Prime to work properly, and after looking it over, I came up with a solution that's worked so far.
I realized that for the little "PEZ dispenser" to properly mate up to the priming lever, I needed to move the primer feed bracket away from the press...
This isn't a "Lee is Junk" thread. I really like my Lee Classic turret press, except for one thing... the ram has a bit more lateral slop than I expected. How much slop does yours have? I can move my ram about 0.012" to 0.015" laterally when it is fully raised and lowered respectively...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.