I've been reloading for a while and usually use Hodgdon's site for double checking data I find in my other reloading manuals. That said, I picked up a Hornady manual as I want to start using SST bullets for deer hunting (loading 243, 250 savage, 7mm-08, and 308). Their book shows load data...
I am going to start loading for the 300 win mag and have a few questions. I have been loading for a while, just never for this. I have some IMR 4831 on hand that I use for 30-06 and was wondering if it is a good powder for the 300 too. I plan on using 180 gn sierra's for an upcoming deer...
What to do? - Decision in post 20
Here's the short short story. I have had Lee presses since I started reloading. They have always done what I needed them to do and have been happy. Tonight while trying to neck down some .308 to 7mm-08 (for my new Ruger Hawkeye) I broke my Classic Cast...
I just picked up a Ruger carbine in 44 mag. I have a few questions on reloading for it and was also looking for any general advise from those who have some experience/knowledge. I currently load 44 mag for ruger revolvers using 23.2 g W296 over a 240 XTP for hunting. Is this a viable load for...
I am new to taper crimping, I have loaded for revolvers for quite a few years, but have now started loading 45 ACP. I am using Hornady dies and with Berry's 230 RN. Here's the problem. I load them and taper crimp to .470. Then I will rack the slide and load the dummy rounds. The OAL goes...
I have a Win 94 in said caliber. Even with a decelerator pad installed, it is a mule to shoot. I would like to be able to shoot it more often, but often times leave it at home due to recoil. Anyone know of any data for reduced loads? I would like to find a "plinking round" for it loading...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.