Search results for query: *

My Sierra 5 is getting a bit “long in tooth”, any word yet on a new edition?

The RCBS is now cast in China and has had some ram problems.

I had two of my best friends ( Soros & Bloomberg ) buy up all of the primers. If you are interested they are available for ONLY $1.00 each. Contact: B. Obama 1600 Penn Ave. Washington, D. C. 20016

What is your cleanest burning powder for 44 SPL and 44 Mag?

I have been using Hornady XTP bullets for years; however I would like to cut the unit cost. I am going to give Zero’s JHP a try. With all of the new manuals being bullet specific I was wondering what equivalent loads to use with Zero’s. I will start with the minimal loads, but are the 110 XTP...

Take a look at this-- http://glocktalk.com/forums/showthread.php?t=78745-

I have a Lee Classic Press that will do anything I ask--and it is a LNL unit. You can remove the large die insert and put the Hornady LNL Adaptor kit in its place for under $20.00! Now I change dies and NEVER have to reset unless I want too.

I am afraid I may have you there, I used my first BAR in 1948!

Great call Grandpa Shooter! You made me rethink the situation, due to the nature of the XTP bullet (long bored center) it requires an exaggerated case mouth opening. I cranked it down and that solved the problem. Thanks!

These are the first on the Lee dies.

The die has a concave seating plug.

I need a little friendly advice. As you can see by the photo, the 38spl case is buldging out on one side. I am using new Starline Brass, Hornady 110gr xtp bullet. Equipment wise, I’m using Lee deluxe 4 die pistol set on a Lee classic ss. Everything is fine until I seat the bullet and I have...

Sort the cases by manufacturer, weigh the cases for volume. Do not use Federal A/E cases—discard them, they are not safe to reload.

It is just an old habit, but I still use a little Imperial wax on my pistol cases when sizing on carbide dies. Am I the only one?