Search results for query: *

With CCW finally happening in Wisconsin it was inevitable that employers would start issuing policies against guns in the workplace. Here is what my employer sent out this week. I understand they have the right to do this. But what about weapons fully enclosed in cases stored out of sight...

I have several 22 rimfire pistols that have a tendancy to collect lead fouling in the forcing cone after several hundred shots. Cleaning this area is a difficult task. I am aware of the Lewis Lead Removal system, but do not see that this is available for 22 rimfire pistols. What is the...

Will 12ga barrels described as for the 870 SP fit a Wingmaster?

For a 243 Winchester my understanding is that the SAAMI cartridge size spec is 1.627"-1.634", and the chamber size spec is 1.630"-1.640". My Forster headspace go gauge is marked 1.630", yet measures 1.622" to the 0.400" datum A new factory Federal cartridge measures 1.622" to the datum...

When drilling and tapping a shotgun barrel for rifle sights, can the hole for the rear sight be drilled through the barrel entirely like the front bead's mounting hole? If yes, is this also permissible in the chamber area?

I am getting a rifle ready for one of my kids and am contemplating cutting a barrel down to 16.5" like the Ruger Compact rifles. Will be cutting some off the butt end of the stock too, and adding a Pachmayr decelerator recoil pad. Will be using 85 or 90 grain bullets at around 2500 to 2600 fps...