Search results for query: *

I have a Rem 788 with a separated bolt handle. Can anyone recommend a knowledgable 'smith who is familiar with repairing the 788 bolt? The silver just let go, no hot loads, no handloads. The bolt was a little sticky when I chambered a dummy round to check die settings. I pulled the bolt back...

Has anyone had any experience loading this round for use in the M96? I was told that Ramshot's Hunter was a good powder but on looking at the pressure data on their sheets the minimal load is already over the recommended 45,000 cpu rating. I plan on using Sierra's 140gr Matchking.

I just got a new barrel bushing and the Chadwick "B" reamer. I can put the bushing in the slide and clamp the slide in a padded vise though I have heard that there are tools to hold the bushing and guide the reamer. Any suggestions on how to ream the bushing straight and square?

I have seen Quickload mentioned here and have seen the demo they offer. How good is the software...the demo is horrendous for trying to figure out how well it works...most of the features I want to examine are turned off. At $150 a copy I want some assurance that it will work for me. I have...

Hi Guys I'm new to THR. I'm glad I stumbled across this forum...lots of interesting posts here. I have a question. I started installing a few parts on my SA 1911...better trigger, extended slide stop, extended thumb safety. After getting everything fitted I noticed that every third or...