What size should the chambers of a .357 be at the forcing cone end? I have a GP-100 of 1988 vintage. I cleaned my cylinder thoroughly with Bore-Clean and a .40 size brass brush on an electric drill. Then I tried to pass a .357" diameter plated bullet through the chambers.
I could push the...
I measured the end of the chambers on my GP-100 and noticed that the diameters were about .355". I couldn't make a 9mm plated bullet go through the chamber without stopping. I load .358" lead bullets and .357" plateds.
Would this chamber size affect performance or accuracy? It seems...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.