Thanks for all the information, fellas.
I went straight out and looked at the Grizzly stuff.
I'd like to know about lathes guys use too, for pistols and for long guns.
Much obliged.
I think havoc7usmc has described what I would like to acheive, armorer with basic machining skills (at least as a first goal, which is lofty enough).
I'm curious as to the small mill you have, havoc. I do other kinds of repair stuff as a hobby (motorcycles) and have done some tightly...
Thanks very much for the Jerry Kuhnhausen recommendation. There are so many books out there on firearms maintenance and gunsmithing an uninitiated person like me has a hard time sorting out the good from the not-so-good.
It makes good sense to use factory parts when you can get them...
Another question
I'm very interested in learning as much as I can about gunsmithing but I'm afraid that I cannot move to another state to attend a brick & mortar training program.
I understand that in terms of getting a paying job as a gunsmith the online degrees are junk.
Is there...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.