Search results for query: *

The opening on the slide stop may be too small. A pillar file will open it up a little.

I had the same problem on a STI 40. I bought a Wilson slide stop with the detent machined in already, cured my headaches... You can take your old slide stop and file a groove at the upper limit where you see the plunger travels. You need to file just a little detent to keep it from bouncing...

How about a mod for the primer punch. I think if they drill it out and put in a hardened bolt they can make the primer seating depth adjustable. I have a hard time seating CCI primers.

I have the same issue with 44 magnum loads I changed primers to Federal and they fit easily. The CCI large pistol primers are a bit more difficult to seat flush. Perhaps a longer lever on the press may provide more leverage. The sharp point on the primer punch will eventually put a...

FYI..sprinco makes a buffered recoil rod (two stage) like the HK USP for the SIG. A heavy spring for the last 1/4" of compression.

Loctite makes an adhesive for dovetails. Check out Brownells.

barrel lock up to the slide is more important on accuracy. Check out the HK USP... the O-rings serve as the "bushing".

what happened to blue revolvers? sigh////

I have a full length rod in my sti and i lost the plug...bugger flew fly a mother... So i bought a new Ed Brown full length rod and it doesn't fit. The "button" on the end is too large, but the plug fits my old rod. I also notice the STI rod is beveled for clearance of the barrel link. Is...