Hey guys,
So I was just at my reloading bench getting ready to load a ton of .224/5.56 rounds for an upcoming event. I haven't loaded this caliber in a while, and I was measuring my sized brass, with a wide degree of results. I know the trim length is 1.750", and the max case length is 1.760"...
As previously posted, I recently bought 250 primed brass cases from an internet vendor. I received 307 cases. :thumbup:
The cases were not in as good a condition as I would have hoped. They were also not uniformly sized. In order to finish processing them and making them ready to go into...
I have previously posted about the fact that when I was a teenager and in my early 20's, I loaded ammunition using components and under circumstances that would make me shudder now.
This weekend, I retrieved the last 500 rounds of that ammunition from storage. It had been assembled in 1982...
A while back I posted asking about tracer bullets in 223/5.56.
I hear they can start fires. :eek:
But, I'm well aware of that, so we're beyond that issue at this point. :)
I'm at the point of starting to actually load some of these bullets into charged cases. I have reduced the charge to...
Years ago when I started loading .223 Remington, I worked up loads using the powders that were available to me at the time. I was shooting a Mini-14 with an 18 inch barrel at the time and so ended up settling on a 60 grain Soft or Hollow point bullet over either IMR-4198, IMR-3031 or WW748. In...
I'm having a few primers not reseating upon firing the round. The rifle is an H&R 1891 heavy barrel. I'm using range pick up FC 223 REM brass 24.6gr of Varget and Sierra 55gr blitz soft points. I thought it might have been a low pressure problem, so I used a lee factory crimp die to test that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.