300

Hello. I just wanted to post my results reloading 300 AAC Blackout with Vectan powders. I was also surprised to see that a few of my extracted cases were missing the primer! I saw no signs of overpressure or unusual noise/recoil. The speeds recorded were less than factory loads. I am using CCI...

Hi everyone, First post here. I just bought a new to me 300 Win Mag benchrest rifle. This is a full custom Clay Spencer Benchrest rifle. The guy I bought it from gave me his handloads data that he had worked up for it. He has a couple world records in benchrest shooting, so he knows what...

Recently purchased a browning x bolt stainless stalker fluted Barrel and factory muzzle brake trying to find the tried and true custom load to tame the beast down a little.

A buddy at work was asking me about it, he was going to switch out an M4 ... it was slow so we googled it, it’s like the 300 Blackout except it uses a full length 223 case and the heaviest bullet it can use a 150 ... I think a 125 would only do a little over 2200 FPS. We decided it was the...

First thread here, I’m going on a Moose hunt in Newfoundland Canada in September of 2019. I’m in need of a new rifle for this hunt and future big game hunts and I was deciding between a 7mm mag or 300 Win mag. Leaning towards a 300 Win Mag based on internet research and previous...

I am currently trying new hand loads that can reach out to 1,000 yards accurately from a cold bore, one to two shots from my 300RUM. I am currently running the 180gr. Nosler Accubond with the IMR 4350 powder. I am using 80.3 grains of powder and the overall length of the round is 3.550". This...