I'm wondering how intense of a gunsmithing job it is to remove/relocate the front sight on a CZ550 and thread the barrel. I'd like to mount a suppressor.
The CZ rep I contacted didn't seem to know if the front sight was screwed + epoxied, screwed + soldered, or just plain screwed on.
Hey everyone, this is going to be a two-part post.
Part I: The Feeding Problem...(happy ending)
So I've had this nice CZ550 American in .308Win for almost a year. It had a problem where the action would bind about .5" before the end of its travel towards the chamber. Picture below:
After...
I finally went and did some long-range shooting! Went out yesterday with a couple buddies just North of the OR border in WA and we had targets out at 1,010 yards (according to the GPS). My initial dope was nearly dead on (used the "Ballistic" app for iOS) and I only adjusted .1mil for elevation...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.