It is an absolute bear to get cartridges into the magazine of my 1895G through the loading gate. The gate pushes easily and springs back fine, but there's a hangup at the end when I load a round.
Once in, I have to push the round a bit forward with the tip of my thumb to get it so the gate will drop for the next round to go in (I can't just push the gate down with the next round, I have to physically nudge the one in the magazine forward with my thumbtip for the gate to move at all).
I'm thinking that the gate default position may be too far outward?
It's almost flush with the receiver edge (even a hair more outward and the rounds would just spring directly into the action immediately). It seems like if it rested further in it all would work smoothly.
Any ideas?
(thanks!)
Once in, I have to push the round a bit forward with the tip of my thumb to get it so the gate will drop for the next round to go in (I can't just push the gate down with the next round, I have to physically nudge the one in the magazine forward with my thumbtip for the gate to move at all).
I'm thinking that the gate default position may be too far outward?
It's almost flush with the receiver edge (even a hair more outward and the rounds would just spring directly into the action immediately). It seems like if it rested further in it all would work smoothly.
Any ideas?
(thanks!)