Loading up some more case and have some Speer nickle plated in standard and +P markings.
About one in 6 primers did not want to seat fully and/or would pop while seating and a small sliver of brass would be in the priming tool.
Using a Lee Turret Press in single stage mode (removed the turning rod) I was priming after flaring the bell and on a few the case needed to be pushed back in the holder fully to seat a primer.
Any ideas to look for? Regular brass hasn't been issue although some RWS was a little stiff getting a primer in. This is all once fired from my guns.
About one in 6 primers did not want to seat fully and/or would pop while seating and a small sliver of brass would be in the priming tool.
Using a Lee Turret Press in single stage mode (removed the turning rod) I was priming after flaring the bell and on a few the case needed to be pushed back in the holder fully to seat a primer.
Any ideas to look for? Regular brass hasn't been issue although some RWS was a little stiff getting a primer in. This is all once fired from my guns.