Anyone know how to detail-strip a CZ 75B w/ Omega trigger?

[Gord]

I'm stuck - slide stop and safety are out, ejector's out, mainspring's still in and none of my remaining FCG parts seem to want to budge. At this point should I just be dropping the mainspring or what?



ETA: Okay, I went ahead and dropped the mainspring and everything's out except the trigger bar, hammer and sear(?) - but the hammer pin doesn't want to come out. Anything further to do or should I just give it a good smack?

 

[Gord]

Sam1911 came to the rescue. FYI to anyone reading this: you've got to rotate the L-shaped piece up until it's straight vertical, then the pin will come out.

 

[Stringfellow]

I've seen some good insight and advice from Sam--we are lucky to have guys like him around!