DragonFire
Member
I assembled my first AR15 from an Olympic Arms stripped lower and a upper kit from Model 1.1
All went well, and all the controls function as they should. But I noticed that there is a slight "wobble" to it. If I put a little side pressue on the pistol grip, the whole receiver seems to twist just a little bit. Not alot, but it is noticeable.
Is that normal?
The only area that I have any second thoughts on was when tightening the buffer tube (it's an A2 stock). I think I snugged up well, but I was worried but bending or otherwise hurting the receiver.
Should I tighten the tube? Any other probable causes/solutions?
FYI: It's 20" varmint flattop, SS heavy barrel. I have a 3-9x scope to mount on it.
All went well, and all the controls function as they should. But I noticed that there is a slight "wobble" to it. If I put a little side pressue on the pistol grip, the whole receiver seems to twist just a little bit. Not alot, but it is noticeable.
Is that normal?
The only area that I have any second thoughts on was when tightening the buffer tube (it's an A2 stock). I think I snugged up well, but I was worried but bending or otherwise hurting the receiver.
Should I tighten the tube? Any other probable causes/solutions?
FYI: It's 20" varmint flattop, SS heavy barrel. I have a 3-9x scope to mount on it.