1-12 INF (M)
Member
- Joined
- Jan 30, 2009
- Messages
- 132
I use a Lee Bulge Buster to correct that little bulge from some Glock range brass and that bit at the bottom that resizing does don't quite reach. But that's a one-at-a-time process.
Has anyone come up with a way to automate this, or do them in bulk?
I was thinking of buying four Bulge Busters and making a plate to fit my Dillon 550 so I could process four cases at once, but is there a better solution?
Has anyone come up with a way to automate this, or do them in bulk?
I was thinking of buying four Bulge Busters and making a plate to fit my Dillon 550 so I could process four cases at once, but is there a better solution?