Bullet pulling die - .38sp lead bullets

[gacajun]

I have an inertia "hammer" type bullet puller that I've been using but wanted to know if there is some type of bullet pulling die that I can mount in my reloading press to pull .38sp lead bullets. I have a Dillon 650XL press and also a Lee Turret press. Is there some die that I can put in my press and pull the bullets rather than having to use the "hammer" puller?

 

[41]

I am pretty new to reloading, but to the best of my knowledge there is not.

I am sure that a more experienced person will be able to confirm or deny my comment shortly.

 

[Archie]

You're thinking of 'collet' type pullers.

They are more expensive but can pull more bullets quicker. I've never used them. You'll have to do some web searching; I'm pretty sure RCBS makes them and some others as well.

I think they work best with jacketed bullets, but may work with lead as well.

Good luck.

I just beat them loose with my inertial.

 

[Paladin38-40]

Hornady Cam Lock Bullet Puller. You will need enough full diameter bullet above the case mouth to get a grip.

 

[Canuck-IL]

Hornady is much less prone to damaging the bullet than the RCBS. Neither however is meant for lead heads - it'll work on some head shapes but probably mess up the bullet pretty badly.
/Bryan

 

[billybob44]

Bullet pulling..

I have used RCBS collet type bullet puller. It can be used in your turret press. You will need the puller die+a .35 collet, to pull your .38 bullets.
I pulled over 1300 .40 S&W loads recently+it works well.
Check MidwayUSA for availability..Bill.