1858rem
Member
which lee handprime shellholder does the 9 mak need...the groove,or rim is deeper than 9 luger, is that any problem or do they use the same shell holder? also, is it worth it to get a lee case length gauge/trimmer for either?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
component help, 9mm mak
- Thread starter 1858rem
- Start date
- Status
-
Not open for further replies.
rcmodel
Member in memoriam
Lee lists both the #19 and #6 hand primer shell holders as fitting the 9mm Luger. The #19 is supposed to be the better fit.
They don't list a shell holder for the hand priming tool for the 9mm MAK.
The MAK die set comes with a #19 press shell holder, so that might work in the hand prime shell holder size too.
rc
They don't list a shell holder for the hand priming tool for the 9mm MAK.
The MAK die set comes with a #19 press shell holder, so that might work in the hand prime shell holder size too.
rc
1858rem
Member
thanks man.
rcmodel
Member in memoriam
I forgot to mention you don't normally need to trim straight wall auto pistol cases.
The taper crimp used on them is not length critical like a revolver roll crimp.
rc
The taper crimp used on them is not length critical like a revolver roll crimp.
rc
Shoney
Member
1858rem
The 9X18 case head is 0.002" less in diameter than the 9X19. The diameter of the 9X18 at the web is only 0.001" less.
Before brass for the 9X18 was widely available, I used to make Mac cases by trimming down and sizing Luger cases.
I use the same shell holder and shell plate for both cartridges.
The 9X18 case head is 0.002" less in diameter than the 9X19. The diameter of the 9X18 at the web is only 0.001" less.
Before brass for the 9X18 was widely available, I used to make Mac cases by trimming down and sizing Luger cases.
I use the same shell holder and shell plate for both cartridges.
- Status
-
Not open for further replies.