CZ 455 scope rings ... what did you use?

[flashhole]

I bought a CZ 455 22 Rimfire. It comes with an 11mm dovetail. I'd like to hear from you as to your scope ring selection. I have my eye on a Weaver RV-7 scope, it has a 1" tube.

 

[61Woody]

I have a set of BKL 257s(Nikon 3-9x40bdc) on one rifle and CZ medium rings(Bushnell Trophy XLT 4-12x40 AO) on the other. Both are working very well for me.

 

[bamajoey]

I have a set of BKL 300 on a 455 Varmint with a Meuller 8-32x44 Target dot. You can go to Rimfire Central, CZ/Brno section, look in the stickies and find more info on scope/ring combos than than the average person can comprehend.

 

[hoghunting]

I have a 452 with the same 11mm dovetail and used a set of rimfire Burris Signature rings and they work perfectly.

 

[ColtPythonElite]

For my 455, I bought a set of air gun rings for less than 10 bucks shipped. Been using them for about a year with no problems. For my 452 FS, I used the Warne 721 rings.

 

[Gtscotty]

I had a set of BKL 257s on my 455, but I've since switched to Warne medium height 22 caliber rings. Either one works

 

[Olympus]

I used the BKLs too. I had Leupold high rings, but they still weren't high enough for my 50mm objective. Been very happy with the BKLs though.

 

[MIL-DOT]

I have a CZ527 on the way now, and after researching rings for it, I went with these from Burris.....
http://www.amazon.com/BURRIS-1-inch-Medium-Rings-420140/dp/B000Q2DO82
I found several reports that these medium height rings allowed sufficient clearance for the both the bolt, and my 40mm scope bell.
These are 16mm, but I would assume they'd make the same ring in 11mm.

 

[berettaprofessor]

On my 452, I just ordered the CZ medium rings.

 

[Coop45]

I use this base and a set of TPS rings.

 

[Ky Larry]

Millet Angle-Locs on all 6 of my CZ rimfires.

 

[Danny Creasy]

Warne 7.3/.22

They have tip-off jaws that can reverse for either 3/8ths inch or 11mm use. However, I have found them less than adequate for 3/8ths inch groves. On the other hand, they are awesome on 11mm CZs. Here is a set on my CZ 452 Special/Trainer:

 

[back40]

on my 455 varmint, i use a DIP 25moa base and seekins precision low rings.

 

[stubbicatt]

I used medium CZ rings on my 452. On my 527 and 550 I use Warne.

 

[flashhole]

Thanks for the replies, I ended up with CZ rings.