DA only revolver

Status
Not open for further replies.
StrawHat said:
This won't work on a S&W revolver, at least not the older ones. I can not comment on Rugers or newer S&Ws. It does work on the Italian C&B revolvers but the OP is not talking of them.
Click to expand...
Why won't this work with older S&Ws. I have bobbed many a hammer with just a Dremel cut off wheel, files and sandpaper. Not hard at all.
 
@ NMPOPS
I had the same question, but I just figured all of the ones I did over the years were done wrong somehow.
 
LAGS Post #19

A Hack saw, and a couple of Mill Files is all that is needed to Bob the Hammer and take three strokes with a file to remove the single action notch.
Click to expand...

NMPOPS Post #26

Why won't this work with older S&Ws. I have bobbed many a hammer with just a Dremel cut off wheel, files and sandpaper. Not hard at all.
Click to expand...

When working on a case-hardened S&W Hammer there is a big difference between a hacksaw blade and a Dremel cut-off wheel. :uhoh:
 
Status
Not open for further replies.
Back
Top