Grips for a Taurus Gaucho

[zxcvbob]

Are there any aftermarket grips to fit a Taurus Gaucho that fills in the area behind the trigger guard so it doesn't whack my knuckle when I shoot .357 Magnums? I think the Gaucho might take Colt SAA grip panels.

I don't have this problem when I shoot my Ruger Bisley even though it recoils a lot heavier. Hogue makes a monogrip to fit Ruger Blackhawks, but I didn't see anything to fit a Gaucho or a SAA. (I'd prefer to have something less ugly than a soft rubber monogrip.) Thanks.

 

[Jim March]

If it was me, I'd take the gun to a gunshop that had at least some Colt SAAs, do an eyeball comparo so see how close they are. If they're ballpark close, since Colts varied over the years their grips are always "oversize" for fitting to a specific gun, which can be home-brewed if necessary.

 

[Gtone]

I have a set of Cherry laminate grips on my Matte SS Gauchos. They look really great. They're made by AJAX.

Gunblast did a review on the Gaucho, and they have a picture of a Colt SAA and Gaucho panel on top of each other. Looked good enough.

 

[bblumen]

http://http://www.grips4guns.com/revolver/taurus/gaucho.html