Sig56
Member
Anyone have suggestions for load development (powder and bullets) for the 375 RDS? I have a very nice Valmet 412S chambered in this Cartridge.
I have 45 Basic new brass as well as some fired cases and a set of RCBS dies for this.
I have reloaded for years but never had something like this where I have to trim the 45 basic case to 2.80 OAL. Do I trim first then run into the sizing die? Any help would be appreciated on the process of creating the 375 RDS and load suggestion for development.
Thanks in advance
I have 45 Basic new brass as well as some fired cases and a set of RCBS dies for this.
I have reloaded for years but never had something like this where I have to trim the 45 basic case to 2.80 OAL. Do I trim first then run into the sizing die? Any help would be appreciated on the process of creating the 375 RDS and load suggestion for development.
Thanks in advance
