fol4321
I don't mean to get to far off the subject, but I have been looking for someone that has the Lyman. Have you ever had any problems with it? I have an RCBS and have replaced one and now the motor on the replacement is starting to growl.
RCBS reluctantly replaced the first one, but I'm not sure if they will do it again. I do use it a lot and this last one is only 2 years old. Maybe I'm expeting too much out of it.
Is the RPM a good speed to preform all the functions? I would assume that all the heads will screw out for replacement, but wondering if the threading allows tools from other manufacturers to be used?
One gets spoiled using these tools to take care of all the menial jobs which are required in handloading and besides, my hands and fingers don't seem to work as good as they used to.