Millet TRS1

[kestak]

Greetings,

I just got a Millet TRS1 and I have a question how to zero it.

There is a lock ring. I know what it is.
There is a turret ring with numbers. I know what it is.
There is a hex screw that get loosen. I do not know what it is.

My question. If I want to zero the scope and I want the turret ring to be setup on the zero, how do I do that with the Millet? the instruction book tis generic and talks about a normal adjusting knob inside a cap.

Thank you

 

[EdLaver]

You loosen the hex screw, slightly (and lightly) pull up on the knob, then turn it to your zero setting, press back down, and tighten the hex again. Caution about the TRS1 though, if you are shooting a long distance and make your adjustments, afterwards they wont always reset back to zero perfect again. I have two and I always fire again at 100 yards after I do long shots to be sure the zero is still set.

 

[kestak]

Thank you!!!
It was so simple that I could not figure it out...LOL :banghead: