brindlpitt1
Member
I asked the question on another forum and got very little response.
I've picked up a frame and slide (from two separate place)and I am planning a build with them.
Both are auto ordnance slide has the Thompson stamp on it.
every other part will be from a quality manufacture.
so what should I look out for?
Pin holes over sized ?
things not square.
or are they as good as anything else.
I couldn't see spending 400.00 plus on a Springfield mill spec only to pitch most of the parts out and start from scratch.
Its going to be a shooter and maybe part time CCW.
no matches no 100,000 rounds a year .
I've picked up a frame and slide (from two separate place)and I am planning a build with them.
Both are auto ordnance slide has the Thompson stamp on it.
every other part will be from a quality manufacture.
so what should I look out for?
Pin holes over sized ?
things not square.
or are they as good as anything else.
I couldn't see spending 400.00 plus on a Springfield mill spec only to pitch most of the parts out and start from scratch.
Its going to be a shooter and maybe part time CCW.
no matches no 100,000 rounds a year .