Ortiges .25ACP firing pin

[UlicniTrkac]

I have just acquired a Ortiges pistol in a very good condition.

But the firing pin is missing, so I have to make a new one. Since old one is missing, I don't have any dimension to work with (I have tried Google of course) so I am asking for your help gents
I do hope someone here has the same pistol, and can take some time to measure his firing pin (all dimensions - body length, pin length, OD, ID, internal protrusion, protrusion of the pin, height of those two "legs" etc) and post it here.
I am not from US, and finding that spare part is impossible. Luckily I have a lathe, so I can make one, and fit it in a slide properly.

Thanks in advance

 

[hartcreek]

I would just go online and make an international purchase if I was you. Numrich Gun Parts also known as Gun Parts Corporation is where I purchased the last one I needed for one of my .32 ACPs.

If all you have is a lathe you will not be able to make the fireing pin.

 

[UlicniTrkac]

and a mill, sorry. I have all I need to make one, just need dimensions

 

[UlicniTrkac]

made it, without drawings or dimensions. i made it from third attempt