Para Ord Warthog?

Status
Not open for further replies.

gbran

Member
Joined
Jan 21, 2003
Messages
2,987
Location
california
Lookin for feedback on the new Para Warthog. 3" bbl, 24 oz, 10+1, 6 1/2" overall length and has the new Para PXT extractor. I am impressed greatly and may buy this, once it has been out long enough to prove itself. I really like 1911's, but my CCW is something else due to weight and size. This model solves those problems.
 
I recently purchased the Para Ord Warthog and all I can say is I LOVE THIS gun! I haven't had it long enough to comment on reliability, but so far I have shot 500 rounds through it. I have never owned a .45ACP and with the Warthogs diminutive size, I was fully expecting to experience a lot of recoil. Imagine to my surprise, it was about the same as my S&W 642 snub nose .38 special +P Airweight, and just a tad more (almost the same) as my Glock 23 .40 caliber. In a few weeks, I fully plan to use it in my IDPA practice rounds as this gun is unbelievably accurate (for its size). For speed shooting, I prefer using my S&W SW99 (essentially a Walther P99) in 9mm as I can control the recoil better. I do not plan on using the Warthog for concealed carry, since its "double-stack" magazine makes it a little thick for me, but this gun would be an awesome conceal carry for the confidence the firepower and accuracy brings. One problem I have had though. About every 50 rounds, I have had misfeads. It did not take long to diagnose. The magazine springs used by Para are VERY stiff. So, loading the mag with 8 rounds instead of 10 was an instant fix. Dealer recommends leaving the mags stored with all 10 rounds for a period of time and that in a month or two, the misfeeds will no longer occur. I shoot several hundred rounds a week, and will probably put at least 300-400 rounds a month through the Warthog, so I will keep you updated of any issues.
 
Never fired one, but i've heard of reliability issues. ('course, i've heard of reliability issues for every gun that tried to make the 1911 design smaller then it should be) Seems like it can be hit or miss with these guns. Most of the time you'll get one that runs prefectly fine, occasionally one that'll be a total PITA to get running right. Becuase the slide is so short they have to be really heavily sprung, which leads to issues.
I'm sure 1911Tuner'll be along in a bit to go on his spiel about shorty 1911s.

They are mighty cool though.
 
Finally got one -- I LOVE IT

I work in a shirt & tie office environment. My 1911 in a Yacqui holster was 'a bit too much' for the environment, so I went with a Para-Ordnance Warthot .45 (the world's smallest .45) in a SkyOps IWB holster that allows me to tuck in my dress shirt at the office and still not print.

Nice. Very Nice.
 
Status
Not open for further replies.
Back
Top