Pietta NMA 1858 Stainless

Status
Not open for further replies.

English Phil

Member
Joined
Apr 14, 2008
Messages
31
Location
Hitchin, Hertfordshire, U.K.
Hi All,

I have examined a second hand Pietta NMA 1858 Stainless which appears to be a great condition, the store owner, (in the U.K.) is selling it for a good price. On checking it over, (I am not that technically minded) the nipples do not seem to line up dead centre with where the hammer strikes, they seem to be slightly offset. I can't check my own one out as it's in AZ, anyone give me a heads up on this.
Thanks.
 
May not matter. I'd ask permission to fire some caps; in lieu of that, which is pretty cheeky so you may not want to do it, put a small piece of waxed paper on one nipple and lower the hammer slowly, then press it down hard onto the nipple. Then lift the hammer and check the piece of paper for a full circle impression. Do each nipple in turn. That should tell you if the hammer is hitting the nipples squarely.
 
You should check the chambers to see if they line up with the bore ...if the nipples are off set in the hammer cut out ...beware , the chambers may be off set to the bore also ..
 
hi phil ,check the cylinder lock up is correct if it is all in all the nipples have to be in the centre of the hammer grove, unless the cylinder pin is bent ,which is easily checked.
 
All Remington Cylinders have Cones or Nipples on and up ward or out ward angle...when locked up at high noon the hammer will strike squarely on the cone...it's the way the Rems were designed. Look close you'll see a slight degree of angle.

SG
 
Smokin Gun got it right in one.That's the design.That stainless Remmie is tough,too.I inadvertedly cut down a small dead tree with one.My brother and I were out on a overgrown logging road ,and had put up a playing card as a mark,on about a 6 to 8 inch frost killed sapling,which had grown up in the middle of the old skid trail.after an afternoon of shooting at the playing card,it was fairly tattered,half gone with the remainder full of holes.as we were loading up the third or fourth cylinder we heard an ominous ''creak'',and the a loud ''CRACK'',and the tree fell off to the side,cut through by eighteen or twenty some soft lead .454 balls.I'd guess the weight of the dead branches probably contributed ,too,but I couldn't help but think about the civil war,and tales of trees being felled by intense musket fire.I'd always kinda doubted those stories...well,not anymore.
 
Status
Not open for further replies.
Back
Top