tcj
Member
- Joined
- Aug 25, 2012
- Messages
- 347
I used 2 sheets of 3/4" hardwood plywood glued & screwed together mounted to a frame of 2x6's (doubled in the front) sitting on 6x6 legs.
The top was then coated with polyurethane.
Underneath I have a 3/4" plywood shelf and the sides & rear are 1/2" plywood.
The top rear of the bench is white pegboard mounted to 2x4 frames (had the wood lying around). On top of the pegboard/top of the frame is a small overhand shelf (about 1/2 the depth of the bench) with lighting below.
This bench doesn't move and doesn't flex in any direction/manner no matter what I'm doing on the press.
The top was then coated with polyurethane.
Underneath I have a 3/4" plywood shelf and the sides & rear are 1/2" plywood.
The top rear of the bench is white pegboard mounted to 2x4 frames (had the wood lying around). On top of the pegboard/top of the frame is a small overhand shelf (about 1/2 the depth of the bench) with lighting below.
This bench doesn't move and doesn't flex in any direction/manner no matter what I'm doing on the press.