Can I take 280 brass and run it through a 30-06 resizing die to make 30-06???? I have a s*#t load of 280 brass and I want to use it instead of buying 06...I was thinking it make rip the necks...whats the consensus.
You can do this-lube the case and run it through a full length resizing die, and you will likely have to trim it. Biggest problem is that you will have to push the shoulder back quite a ways.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.