born to hunt
Member
- Joined
- Sep 25, 2009
- Messages
- 26
Need some guidance here.
I'm on my 5th loading of my 300 wsm brass and I notice the bolt is becoming "snug" to close. (Tikka T3stainless) I've only neck sized to this point, with only one round of trimming to length. Last night I FL resized one case andit chambered easily again. My question: is there a way to measure how far back I need to bump the shoulders, or should I just FL size all and start over? If I do FL size all, how much of a difference have you notiiced on your neck sized VS. full length sized reloads? I have the load where I want it (under 3" at 310 yards) and I'm worried FL sizing will screw it up.
My load is 168 barnes TTSX on top of 70 grains of RL22 at 3080fps.
Thanks!
bob
I'm on my 5th loading of my 300 wsm brass and I notice the bolt is becoming "snug" to close. (Tikka T3stainless) I've only neck sized to this point, with only one round of trimming to length. Last night I FL resized one case andit chambered easily again. My question: is there a way to measure how far back I need to bump the shoulders, or should I just FL size all and start over? If I do FL size all, how much of a difference have you notiiced on your neck sized VS. full length sized reloads? I have the load where I want it (under 3" at 310 yards) and I'm worried FL sizing will screw it up.
My load is 168 barnes TTSX on top of 70 grains of RL22 at 3080fps.
Thanks!
bob